Burley Trailer - Setting Up and Folding Your Burley-Solo; Install Side Rails

6
V. Setting Up and Knocking Down Your
Burley-Solo
Setting up or knocking down your Burley-Solo is accomplished in a few
easy steps involving the side rails, the roll bar and cover, the tongue, and
the safety fl ag.
Install Side Rails
Ensure that all four of the plastic side-panel hold-downs (C-shaped) on the
main frame are fl ipped to the outside of the Burley-Solo (see illustration
below). Slide each side rail down over the 2" tall aluminum side-rail guides
at the front and rear of each side of the main frame.
Side-Panel Hold-Down
(Snapped in Place)
Side-Panel Hold-Down
(Snapped in Place)
Side Rail
Right Rear
Right Front
Side Rail
Side Rail
Side-Panel Hold-Down
(Flipped Open)
Side-Panel Hold-Down
(Flipped Open)
Side-Rail
Guide
Right Front
Side-Rail
Guide
Right Rear
Side Rail