57
Clean the board with a damp sponge after use. For heavier soiling, use some mild detergent. Never put
the board in the dishwasher. Do not leave it in the dishwasher or water for a long time. Treat the cutting
board regularly with a suitable maintenance oil.
Problem Possible cause Solution
Burner does not ignite
Gas cylinder is empty Connect new gas cylinder
Faulty pressure regulator
Have the pressure regulator
checked by a specialist dealer
Impurities in the burner Clean the burner
Impurities in the ignition system or
gas hose
Clean the ignition and gas hose
Battery of the ignition electrode is
empty
Replace battery
Connection cable to ignition elec-
trode or burners is not correctly
attached or dirty
Check if all cables are correctly
connected to the ignition ele-
ment of the burners and to the
ignition electrode.
Small flame / little heat or
flash fire in the burner
Impurities in the burner Clean the ignition and gas hose
Windy conditions
Place the appliance in a more
sheltered position
Burner not seated correctly Remove and reinsert burner
Grill is too hot/heavy smoke
Control knob is set too high Turn down the control knob
Excess fat burns off Clean the grill
Pressure regulator is defective Replace pressure regulator.
TROUBLESHOOTING
To Next Page
Loading...
