49
This is harmless. Make sure the grill is ventilated adequately. Afterwards, use a brass
brush to scrub over the cast iron grates.
The colour on the inside of the gas grill may change slightly. This is a natural process.
Igniting the gas grill
1. Open the grill lid.
2. Turn all control knobs clockwise to
the “OFF” position.
3. Connect the pressure regulator to
the gas cylinder.
4. Open the gas cylinder valve and
use a leak detection spray or soapy
water to check for leaks between
the gas pressure regulator and the
gas cylinder.
5. You can light the burners indepen-
dently.
6. Press and hold down one of the
knobs while turning it anticlockwise
to the “HI” position. You will hear a
“click” sound and the burner should
ignite. If it does not ignite right
away, repeat this step 3 to 4 times.
7. Warning: If the burner does not
ignite after repeated attempts, turn
the knob clockwise to the “OFF”
position and close the gas cylinder
valve. Wait 5 minutes and then start
again from step 4.
8. Once you have ignited the burner,
repeat steps 6 and 7 with the other
knob to ignite the second burner.
9. Adjust the heat by turning the
control knob to the desired setting
between the highest (“HI”) and
lowest (“LO”) levels.
Switching off the gas grill
1. Close the gas cylinder valve and
turn all knobs clockwise to the
“OFF” position.
2. If you only want to turn off the
grill, turn the knob clockwise to the
“OFF” position.
To Next Page
Loading...
