Opamp Change & Upgrade
The Burson Funk allows opamp changing to customise its sound to the owner’s preference. When
changing opamps, please be aware of the following:
1. The opamp power supply voltage in the Burson Funk is +/-15V. Always remove the power
supply before opening up the unit.
2. There are 2 dual opamps inside the Funk.
3. Please refer to the following diagram for the position and correct orientation of the opamps.
The notch at the top of the opamp indicates the orientation of the opamp within the socket.
Match it to the existing opamp.
4. The case can be opened by removing 4 hex screws at the bottom of the case. Use the
supplied hex key.
To Next Page
Loading...
