49
SPECIFIC SETPOINT DETAILS FOR 9181
• In 9181 the auto track is not available.
•
When a short reaction time is necessary, should be used the 4OP ó 4OPP options.
•
To use the “fast” output activation mode they must be programmed in the MENU 3B the first digit to 1 or 2 and the
fourth digit to 0.
• When there is positive overflow ( OVFLO ) or negative overflow (-OVFLO), The output goes to repose mode (depending on
the programming of the fiftth digit in the menu MODE 3B) except if they are programmed in LATCH mode , in this case
they will be kept activated.
55
RS2-RS4
SERIAL INTERFACE
ANNEX
Valid only for 9181
See Vxx1x manual
See Vxx2x manual
To Next Page
Loading...
