Burster 9243 - Operating Conditions; Restrictions on Use; Cleaning; Personnel

9 of 35
2.4.2 Operating conditions
The following requirements must be met when operating the 9243 amplifier module:
• Always operate indoors
• Maximum height above sea level 2000 m
• Operate at temperatures between 0 °C and 60 °C
• Humidity: 80% up to +31 °C, decreasing linearly above that temperature to 50% at
T
max
, no condensation
• Class of protection: 3
• Transient overvoltage category: CAT II
• Supply voltage 11 ... 30 VDC
Note: Avoid condensation forming after transportation or storage.
2.4.3 Restrictions on use
The the 9243 amplifier module does not pose a hazard if used within its specification and in
accordance with the safety regulations.
The manufacturer does not accept liability for any personal injury or property damage arising
from misinterpretation of measurement results.
Note: The the 9243 amplifier module is not intended as a substitute for safety devices and protective
equipment. Use safety devices and protective equipment.
2.4.4 Cleaning
DANGER
Electrical shock hazard
Disconnect the 9243 amplifier module from the power supply before cleaning.
Disconnect the 9243 amplifier module from the power supply and use a slightly damp cloth for
cleaning the unit.
CAUTION
Do not immerse the 9243 amplifier module in water or hold it under running water. Do
not use strong cleaning agents as these may damage the 9243 amplifier module. Use
a slightly damp cloth to clean the 9243 amplifier module.
2.5 Personnel
Personnel must be familiar with the relevant regulations. They must follow these regulations.
Only trained personnel who are familiar with the applicable safety regulations are permitted to
operate the 9243 amplifier module.
burster is happy to provide your operating personnel with training on the 9243 amplifier module.
To find out more, please look at our range of services at www.burster.com
.