4 AIM-50™ Installation Manual − Wall Mount Version 5000145 A01
Symbols Used in This Manual
WARNING Disregarding this instruction can present the risk of a serious or fatal injury.
CAUTION
Disregarding this instruction can result in medium to light injury and damage to
property.
IMPORTANT Provides usage tips and useful information.
Transportation and Storage
The following storage conditions apply:
• Temperature: 0 - 70 ºC (32-158ºF)
• Relative humidity: 10 - 75 % (no condensation)
• Air pressure: 500 - 1060 hPa
Store only in closed or covered spaces; thereafter, the values of the operating conditions in the
usage instructions apply.
Safety Precautions
WARNING
Failure to properly follow installation and preventive maintenance instructions
may result in mechanical failure.
WARNING
Before undertaking any work, ensure that the branch circuit power is off and
secured from accidentally being switched on again.
NOTE
This light should only be installed by qualified electrical and structural
contractors*.
NOTE
It is the responsibility of the customer to make sure the supporting wall /
ceiling and the anchoring is safe, adequately strong and in compliance with all
applicable building codes. (See: Static inspection on page 14 and the section
Support and Anchorage below.)
*Approved wiring shall be routed inside conduit between the wall switch junction box and the steel support plate (to
the wall mount). The installation shall meet requirements contained in the latest issues of the NEC and NFPA, and
other local and national building codes; as they apply to hospitals, clinics, medical offices, and the like.
To Next Page
Loading...