BUSCH Fossa FO 0015 A - Connecting Lines; Pipes; Suction Connection

5 | Installation
12 | 40 Instruction Manual FOSSA FO 0015 A - FO 0035 B_EN_en
If additional electrical components not included in scope of delivery should be added:
● Make sure that they have a better or equal ATEX classification than that of the machine, see the
ATEX marking on the nameplate (NP).
5.2 Connecting Lines / Pipes
WARNING
The connection lines can build up an electrostatic charge.
Risk of severe injury!
Risk of explosion!
● The connection lines must be made out of conductive material or provisions must be made
against creating an electrostatic charge.
● Remove all protective covers before installation.
● Make sure that the connection lines cause no stress on the connection of the machine; if neces-
sary use flexible joints.
● Make sure that the line size of the connection lines over the entire length is at least as large as
the connections of the machine.
In case of long connection lines, it is advisable to use larger line sizes in order to avoid a loss of effi-
ciency. Seek advice from your Busch representative.
5.2.1 Suction Connection
WARNING
Unprotected suction connection.
Risk of severe injury!
● Keep long hair, loose articles of clothing, etc. away from suction connection.
NOTICE
Ingress of foreign objects or liquids.
Risk of damage to the machine!
If the inlet gas contains dust or other foreign solid particles:
● Install a suitable filter (5micron or less) upstream from the machine.
NOTICE
Ingress of foreign objects or liquids.
Risk of damage to the machine!
If the inlet gas contains dust or other foreign solid particles:
● Install a suitable ATEX inlet filter (5micron or less) upstream from the machine.
Connection size(s):