Installation | 5
0870220060_MH0018A_-0001_IM_en 7 / 40
• Make sure that the environment of the machine is not potentially explosive.
• Make sure that the ambient conditions comply with the Technical Data [►34].
• Make sure that the machine surface is clean from dust and dirt to guarantee an effi-
cient cooling.
• Make sure that the installation space or location is vented such that sufficient cooling
of the machine is provided.
• We strongly recommend to install the product at the top level of the fluid circuit to
avoid the stagnation of condensates inside the compression stage.
• Make sure that all provided covers, guards, hoods, etc. are mounted.
WARNING
Vibration level.
Risk of premature failure!
• Make sure the product is protected from external shocks. Regarding vibration level,
please contact your Busch representative to discuss the corresponding levels.
5.2 Connecting Lines / Pipes
WARNING
Unprotected connection.
Risk of severe injury!
• Do not put hand or fingers in the connection.
• Remove all protective covers before installation.
• Make sure that the connection lines cause no stress on the machine‘s connection; if
necessary use flexible joints.
• Make sure that the line size of the connection lines over the entire length is at least as
large as the connections of the machine.
In case of very long connection lines it is advisable to use larger line sizes in order to
avoid a loss of efficiency. Seek advice from your Busch representative.
• Make sure that the connections are “face sealed” and not “thread sealed” to ensure
tightness.
To Next Page
Loading...
