How to fix a noisy BUSCH Mink MV 0060 C Water Pump?
If your BUSCH Water Pump is running very noisily, it could be due to: a low oil level, in which case you should top up the oil; or defective bearings, in which case you will need to repair the machine.
What to do if BUSCH Mink MV 0060 C doesn't reach usual pressure?
If your BUSCH Water Pump isn't reaching the usual pressure, it might be because the inlet screen is partially clogged, so you should clean it. Alternatively, the inlet filter cartridge might be partially clogged, so replace it. It is also possible that internal parts are worn or damaged, in which case you should repair the machine.
General| Model | MV 0060 C |
|---|---|
| Nominal Pumping Speed | 60 m³/h |
| Weight | 85 kg |
| Voltage | 200-240/346-415 V |
| Frequency | 50/60 Hz |
| Pumping speed | 60 m³/h |
| Type | Claw |
Specifies environmental, spatial, and operational requirements for safe installation.
Provides instructions and recommendations for connecting suction and discharge lines.
Details the procedure and precautions for filling the machine with the correct type of oil.
Provides critical safety guidance and requirements for electrical hookup.
Details the procedure for resetting faults and preventing inadvertent start-up.
Outlines recommended maintenance intervals and specific tasks for regular upkeep.
To Next Page
