Why is my BUSCH Water Pump running too hot?
Your BUSCH Water Pump may be running too hot due to several reasons. Insufficient cooling can cause overheating, so remove any dust and dirt from the machine. High ambient temperature or high process gases temperature at the inlet could also be the cause. Make sure to check the permitted ambient and gas inlet temperatures in the Technical Data. Also, check the oil level and top up if it is low.
Why is my BUSCH Mink MV 0080 C running very noisily?
If your BUSCH Water Pump is running very noisily, it could be due to a low oil level. Top up the oil. Another possible cause is defective bearings.
What to do if my BUSCH Water Pump does not reach the usual pressure?
If your BUSCH Water Pump isn't reaching its usual suction pressure, it might be because the inlet screen is partially clogged. Clean the inlet screen. If your pump has an optional inlet filter cartridge, that could be partially clogged too, so replace it.
Why is my BUSCH Water Pump showing an overvoltage error?
If your BUSCH Water Pump shows an overvoltage error, it means the DC-link voltage has exceeded defined limits. You should check the input voltage to resolve this.
What to do if my BUSCH Water Pump displays an undervoltage error?
If your BUSCH Water Pump shows an undervoltage error, it indicates that the DC-link voltage is below the defined voltage limits. If there was a temporary supply voltage break, reset the fault and restart the AC drive. Check the supply voltage. If the supply voltage is adequate, an internal failure has occurred, so repair the vacuum pump (Busch Service).
What does 'Input phase' mean on my BUSCH Mink MV 0080 C Water Pump?
If your BUSCH Water Pump reports an input phase issue, it means an input line phase is missing. Check the supply voltage, fuses, and cable.
What to do if my BUSCH Mink MV 0080 C has a system fault?
If your BUSCH Water Pump shows a system fault, it indicates a component fault or malfunction. Reset the fault and restart the system. If the fault reoccurs, contact your Busch representative.
What does earth fault mean on a BUSCH Mink MV 0080 C, and how do I fix it?
If your BUSCH Water Pump indicates an earth fault, it suggests insulation failure in the motor cable. Check the motor cables and the motor itself.
Why my BUSCH Mink MV 0080 C does not start?
Your BUSCH Water Pump might not be starting due to a few reasons. First, the motor may not be getting the correct voltage, so check the power supply. Second, the motor itself might be defective, requiring you to repair the machine.
What to do if my BUSCH Mink MV 0080 C Water Pump runs too hot?
If your BUSCH Water Pump is running too hot, there are several potential causes: * Insufficient cooling: Remove any dust and dirt from the machine. * Ambient temperature too high: Make sure to check the permitted ambient temperature. * Temperature of the process gases at the inlet too high: Check the permitted gas inlet temperature. * Oil level too low: Add more oil.
General| Brand | BUSCH |
|---|---|
| Model | Mink MV 0080 C |
| Category | Water Pump |
| Language | English |
To Next Page
