Bush AX27 - Install the Gas Struts

AX27 Clamshell Tent
The Bush Company www.thebushcompany.com
AX27 Instructions v2.0.docx Last Updated: 11/09/2023 11:51:00 AM
5
2 Install the Gas Struts To Your Tent
INSTRUCTION
PRESENTATION
STEP 1:
• OPEN THE TENT AND REMOVE THE GAS
STRUTS, LADDER AND SPRING RODS.
• CLOSE THE TENT .
STEP 2:
• IDENTIFY THE TOP OF THE GAS STRUT.
• REMOVE THE SPRING FROM THE BALL AND
SOCKET END POINTS
• REMOVE THE BALL JOINTS FROM BOTH ENDS
OF THE GAS STRUTS .
STEP 3:
• APPLY THE FOLLOWING TO BOTH SIDES OF THE
TENT.
• REMOVE THE BLACK BUTTON HEAD SCREW
FROM THE GAS STRUT BRACKET ON THE TOP
SHELL.
• REMOVE THE EXISTING WASHER & PLACE IT
OVER THE TOP PART OF THE GAS STRUTS’
THREAD.
• SCREW THE TOP PART OF THE GAS STRUT INTO
THE NUT, HELD IN PLACE BY THE BLACK
BUTTON HEAD SCREW. ENSURE TO PROPERLY
FASTEN THE BALL JOINT.
•
TOP
BOTTOM