Installing your tumble dryer
Bringing it all together
Installing your
16
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
ADJUSTING THE FEET
• For the dryer to work with less noise and vibration, it
must be stable and balanced on its feet. Adjust the
feed to ensure that the product is balanced.
• Rotate the feet to the right and to the left until the
dryer is even and stable.
IMPORTANT: Never remove the adjustable feet.
ELECTRICAL CONNECTION
ATTENTION: There is risk of fire and electric shock.
• Your dryer is set to 220-240 V and 50 Hz.
• The mains cable of the dryer is equipped with a special
plug. This plug must be connected to an earthed
socket protected by a fuse of 16 Amperes as indicated
on the type plate. The fuse current rating of the power
line where the outlet is connected must also be 16
amperes. Consult a qualified electrician if you do not
have such an outlet or fuse.
• Our company cannot be held responsible for damages
resulting from usage without earthing.
IMPORTANT: Operating your machine at low voltage
values will shorten the service life and decrease the
performance of your machine.
UNDER COUNTER INSTALLATION
• Leave at least 3 cm of space between the side and rear
walls of the product and the underside of the worktop
when installing your product under a counter.
• Assembly / disassembly under the counter if
necessary must be done by authorized service.
To Next Page
Loading...
