Care and maintenance
Looking after your appliance
Care and maintenance
31
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
CLEANING AND CARE
IMPORTANT: Do not use industrial chemicals to
clean your dryer. Do not use a dryer that has been
cleaned with industrial chemicals.
CLEANING THE LINT FILTERS
IMPORTANT: DO NOT FORGET TO CLEAN THE
LINT FILTERS AFTER EACH USE.
To clean the lint lters:
1. Open the loading door.
2. Pull up the lint lters to remove it.
3. Open the outer lter
4. Clean the outer lter by your hands or using a soft
cloth.
5. Open the inner lter
6. Clean the inner lter by your hands or using a soft
cloth
7. Close the lters and t the hooks
8. Place inner lter inside of outer lter
9. Ret the Lint lter
After the dryer has been used for a certain period of
time, if you encounter a layer that will cause
obstruction on the lter surface, wash the lter with
warm water to clean the layer. Dry the lter thoroughly
before reinstalling it again.
EMPTYING THE WATER TANK
1. Pull the drawer cover and carefully take out the
tank.
2. Empty the water in the tank.
3. If there is lint accumulated on the discharge cap in
the tank, clean it with water.
4. Refit the water tank.
IMPORTANT: Never remove the water tank when
the programme is running. The water condensed in the
water tank is not suitable for human consumption.
IMPORTANT: DO NOT FORGET TO EMPTY THE
WATER TANK AFTER EACH USE.
1
2
To Next Page
Loading...
