Bush BCGBTD8HP - Page 36

Product support
Help is always at hand
Product support 36
If you require any technical guidance or find that your product is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
or online at www.bush-support.com If you still require further assistance, call one of our experts on 0345 257 7271.
PROBLEM REASON SOLUTION
Clothes have shrunk, felted or
deteriorated.
The programme used might not be
suitable for the type of laundry.
Check the care labels on the
laundry items, select a suitable
programme for the type of laundry.
Water leaking from the loading door. There might be lint accumulated on
the inner surfaces of the loading
door and on the surfaces of the
gasket of the loading door.
Clean the inner surfaces of the
loading door and the surfaces of the
gasket of the loading door.
The loading door opens on its own. The loading door might not be
closed properly.
Push the loading door until you hear
the closing sound.
The water tank warning symbol is
on/ashing.
The water tank might be full. Empty the water tank.
The water discharge hose might
be bent.
If the product is connected directly
to the water outlet, check the water
discharge hose.
The lter cleaning warning symbol
is on.
The lint lter might be unclean. Clean the lter.
The lter seat might be clogged
by lint.
Clean the lter seat.
There might be a layer that causes
obstruction on the surface of the
lint lter.
Wash the lter with lukewarm water.
The heat exchanger cleaning
warning symbol is on.
The heat exchanger might be
unclean.
Clean the heat exchanger.
The lter and heat exchanger
cleaning warning symbol are
ashing.
The lter seat might be clogged
by lint.
Clean the lter seat.
There might be a layer that causes
obstruction on the surface of the
lint lter.
Wash the lter with lukewarm water.
The heat exchanger might be
clogged.
Clean the heat exchanger.
The program can not be started and
the lter warning led is blinking.
The lter may not be placed. Replace the lter.
The lter warning led is blinking
even though the lter is placed.
Call technical service.
The programme has been
interrupted for no reason.
The loading door might not be
closed properly.
Make sure that the loading door is
properly closed.
There might have been a power
failure.
Press the Start/Pause key to start
the programme.
The water tank might be full. Empty the water tank.