Troubleshooting
18
Troubleshooting
Thermal cut-out
This vacuum cleaner is tted with a thermal cut out that protects
the cleaner if the motor overheats. If the cleaner stops suddenly of
its own accord, follow this procedure:
1 Switch off the vacuum cleaner and unplug from the mains
supply.
2 Check for the source of the overheating problem (blocked hose,
clogged lter etc.).
3 Unblock the hose, empty the dust container and clean the lters
if required.
4 Wait for approximately 30-40 minutes to allow the motor to
cool.
5 After 30-40 minutes, plug in the vacuum cleaner and switch it
on. The vacuum cleaner should now work.
6 If it still does not work, wait another 20 minutes and try again.
If your cleaner is still not functioning correctly, please contact the
BUSH helpline on 1800 509 394 in Australia or 0800 450 259 in
New Zealand.
Disposal
At the end of its useful life, please dispose of this
vacuum cleaner in an environmentally friendly manner.
To Next Page
Loading...
