20
Using your DAB+/FM Radio
Let’s get started
Time /Date
Backlight:
1. Set Time/Date
The date and time are displayed as mm-dd-yyyy with the first value, mm, active (flashing).
Adjust each value with the dial control. As each value is set by pressing the OK/Volume dial
control, the next value becomes active ready for adjustment.
2. Auto-update (from any, from DAB, from FM) or No update
Select Update from any, from DAB, or from FM.
Note that if you are updating the time from DAB or FM, Radio will auto-update from the
selected source when time information is available.
3. Set 12/24 Hour format
Allows you to change between 12 and 24 hour display.
4. Set Date Format
Allows you to change between DD-MM-YYYY to MM-DD-YYYY.
You can configure the display lighting under BACKLIGHT:
– Dim the display in standby mode after a pre-determined time
– Display brightness
Setting the dim time, Choose Timeout: “on” – “10 sec” – “20 sec” – “30 sec” – “45 sec” – “60
sec” – “90 sec” – “120 sec” – “180 sec”, press the OK/Volume dial to confirm.
Display brightness during operation
Select On level and choose “High” – “Medium” – “Low”, press the OK/Volume dial to confirm.
Display brightness in standby mode
Select DIM level and choose “High” – “Medium” – “Low”, press the OK/Volume dial to
confirm.
To Next Page
Loading...
