22
Using your DAB+/FM Radio
Let’s get started
DAB operation
Press Mode button to switch to DAB mode.
Full Scan
1. Extend the telescopic antenna for the best reception possible.
2. Press Power button to power up the DAB Radio.
3. A full scan will automatically commence when first power on. The unit will search for all
available DAB stations.
4. To start a scan manually, press Scan button or select Menu > Full scan. Once the scan is
completed, the radio will play the first station, press Previous or Next button to check station
list, shows a list of available stations
Manual tune
The manual tune menu option allows the user to select a particular channel and display the
signal strength for that channel.
DAB Display modes, station Information on DAB Mode
Signal Strength: Displays a signal bar with the strength of the current station.
Bit Error Rate (BER): Provides details of the signal error rate.
Channel and Frequency: Displays the station’s transmission channel number and frequency.
PTY (Program Type): Shows the type and description of the program provided by the DAB
station.
Time and Date: Displays the time and date information provided by the broadcaster.
Dynamic Label Segment (DLS): Displays scrolling text information supplied by the broadcaster.
Bit Rate: The data rate of which the signal is being transmitted
Prune / Removing Stations
1. When the DAB Radio has performed a scan in several locations you may find there are stored
stations that you can no longer receive. This function automatically removes them from the
stored station list.
2. Press the MENU button to enter Prune Invalid, then press the OK/Volume
dial to confirm and select YES then press the OK/Volume dial to remove.
To Next Page
Loading...
