4
ACTIVATING/REPLACING THE BATTERY
ACTIVATING THE INSTALLED BATTERY: A CR2 battery is pre-installed in your new Pro XE.
Before using the rangender, remove the battery cover as described above. Remove the
red plastic protective disc (see photo, right) from the top of the battery, then replace the
battery cover.
REPLACING A LOW BATTERY
Note: It is recommended that the battery be replaced at least once every 6 months.
BASIC OPERATION
(see “Adjusting the Eyepiece” below). Place
Note: Once activated, the display will remain active and display the last distance measurement for 10 seconds. You can
depress the Power/Fire button again at any time to distance to a new target. The maximum time the laser is transmitted
(fired) is 5 seconds. To re-fire, press the button down again.
ADJUSTING THE EYEPIECE
SLOPE-SWITCH TECHNOLOGY
DISPLAY INDICATORS
(refer to display image at right):
(surrounding crosshairs indicate laser transmission)
Battery Level
(based on Slope/Elements)
(% grade)
BATTERY LIFE INDICATOR
•
•
•
•
ACTIVE LASER
6
45
3
2
7
1
To Next Page
Loading...
