BUSHWACKER BIG EYE D3 - Connecting to TV; Language; Firmware Upgrades

16
4.4 Connecting to TV
Use the camera’s TV cable connects to TV RCA directly, Switch camera
to “TEST” mode, choose “REPLAY” to review photos/videos in TV.
Note: After connect to TV, TFT screen will shutdown
automatically to save power!
4.5 Language
System language, Users can choose different language version to
purchase. Default setting is “English”. User can view version number of
different language on official website.
4.6 Firmware Upgrades
The manufacturer reserves the right to upgrade the camera and the
firmware. Users can upgrades firmware through SD card (SD card
capacity less than 32GB)
Follow the steps below to implement the upgrades:
1) Ready a SD cart and format the SD card;
2) Copy the “FWD3A.bin” file into root directory of the SD
card;
3) Insert SD card to camera, while press "OK" button switch
camera to “TEST” mode, after red light flashes loosen the
“OK” button.
4) Upgrading is underway when red indicator light flashes
continually and TFT screen is off. Keep power on until TFT
screen turn on and upgrade process finish (upgrade process
needs 1minute).
5) Restart and check if the new version number is the same as
the old one, to confirm upgrade process succeed.
Perform the upgrade step again if failure.