6
On “TEST” mode when battery power level gets low, the message
“Battery Low” will show on TFT screen(the battery icon in bottom right
corner is empty and marked with red “X”); In “ON” mode, red indicator
light flashes 60 seconds.
1.5.2 SD Card
Please insert SD card correctly. Photos are saved in JPEG and videos are
saved in MOV. The supported memory capacity is up to 64GB. It’s
recommended to use high speed SD card not less than class 10 to achieve
the best performance. Please don’t take out batteries, SD card or power
supply when camera in “ON” mode!
Note: Before insert SD card, please make sure the write-protect
switch on the side of the SD card “off” (not in the “Lock”
position).Installed correctly and format SD card to prevent any failure.
1.5.3 Others
On “TEST” mode, camera will be auto power off while no keypad
controlling. Please switch to “TEST” mode again if you want to continue
to use. Auto power off time can be set by users.
Please keep power on during upgrade process. After finishes upgrade, it
needs to keep at least 5seconds before you can shut down or cut off
power, otherwise it may causes upgrade failure.
When install camera please make sure there are not moving objects in
3m area in front of lens such as branches, leaves, weeds, strings, color
ribbon and other objects which may fluttered in the wind to avoid
potential false triggers.
Please do not aim the camera at a heat source such as boiler, exhaust
vents and light, etc. Avoid mistaking photos or videos and shortening
stand-by time.
1.6 Menu
Press “MENU” button to switch between “Image” “Set” and “System”.
Select different parameters by moving ▲/▼,press ◄/► to change the
setting, “OK” to confirm the change, press “REPLAY” to enter into
replay mode, press “EXIT” to return to the previous menu or exit.
To Next Page
Loading...