BUTURE BR700 - Smart Clamp Connection Status; Vehicle Start Failure; Successful Start and Protection State

Connect the smart
clamp to the flat
battery
The green light
is always on
Start the vehicle
The red light is
always on and
sound a long
alarm
The green light
is always on
The red light
flashing and
sound a long
alarm
Fail to start the
vehicle in 30s
Starting current
of the vehicle is
too large
Start the flat battery
successfully, enter
anti-recharge
protection state
Please disconnect it
from the car battery
and jump starter,
then wait for at least
20 seconds before
reconnecting.
Please disconnect it
from the car battery
and jump starter,
then wait for at least
20 seconds before
reconnecting.
Please remove the
battery clamp from
the car battery and
the jump starter
within 30s
The red light is
always on and
sound a short
alarm
The red light is
always on and
sound a long
alarm
Continue to the
next step
The smart clamp
is reversely
connected
The smart clamp is
short-circuited
.
please check
whether the red
and black clamps
together connector
connect both cable
clamps to the same
piece of metal
Please disconnect it
from the car battery
and jump starter,
then wait for at least
20 seconds before
reconnecting
Work status
12
EN