In any of the following situations, the smart clamp turns protection on:
Step 4: Turn the ON/OFF Button on to start the air compressor and inflate the tire.
Once the pre-set pressure has been met the device will automatically shut itself off.
Then please turn the ON/OFF Button off to shut the device completely, disconnect
the air hose, and replace the dust cap you have taken off.
NOTE: To extend the service life, do not
inflate for more than 8 minutes at any one
time. If using for extended periods, after inflating for 8 minutes, please let the device
rest for 5 minutes allowing for it to cool down.
Insert the plug of
the smart clamps
completely into
the jump starter
Ready to work
Please check the
jump starter or
fully charge it
Continue to the
next step
Low power of the
jump starter
Step LED Indicator Situations Suggestion
The red light
flashing and sound
a
long alarm
The red/green
light flashing
alternately
11
EN
To Next Page
Loading...
