Step 3: Start the vehicle.
If the engine does not start on the first try, disconnect it from the car battery and wait
for at least 20 seconds before reconnecting.
Step 4: When the vehicle is started, remove the battery clamp from the car battery
and the jump starter within 30 seconds.
NOTE: After the green light of the smart clip is always on (work status), do not
disconnected or change the connection between the clip an
d the car battery to avoid
short circuits or reverse connection.
Step 2: Connect the red damp to the positive electrode (+) of the car battery and the
black clamp to negative one (-)
08
EN
To Next Page
Loading...
