BUTURE BR700 - Jump Starting Your Car; Step 1: Insert Battery Clamps

- Be sure to turn off all electronics in your car (radio, lights, etc.) before jump starting.
- Make sure you are in a dry, well-ventilated area. Never jump start a vehicle in an
enclosed area.
- Remove any moisture from your jump starter unit, accessories, and your vehicle's
battery. Never attempt to jump start a vehicle when moisture is present. Check that
the vehicle's battery terminals are dean to ensure the best conductivity.
- Properly identify the vehicle battery's positive (+, red) and negative (-, black
terminals before connecting the clamps.
- When using the damps, do not allow the metal teeth of the black clamp to touch the
metal teeth of the red damp.
- When using the damps, DO NOT connect the RED damp to the vehicle battery
negative (-) terminal, or the BLACK damp to the vehicle battery's positive (+)terminal.
- When connecting smart damps to the battery terminals, ensure the copper teeth on
each side of the clamp make good contact with the terminal. The better the
connection, the easier it will be to start your vehicle.
NOTE: When adjusting the clamps please be sure to disconnect your Jump Starter
first. This will prevent the occurrence of minor sparks.
Step 1: Insert the plug of the battery damps completely into the jump starter, the red
and green lights flashing
alternately.
To Jump Start Your Car
07
EN