BUTURE JR700 - Clean the Roller Brush

X sales@ibuture.com
8.3 Clean the brush
A\ Ensure the appliance is disconnected from the charger before removing the roller brush. Be careful not to pull the ON button.
(1 Push up the switch to the “unlock” side, remove the 2 Use the small cleaning brush to sweep away
plug, then take out the roller brush. the trash on the roller. The knife side used to remove
the tangled hairs from brush roller.
(3 Clean the roller brush with/without water. @ Push in gently to install the roller brush. Before replacing,
make sure the brush is completely dry.
min N
N\
IREN )