BUTURE JR700 - Page 14

Problems Possible Causes Solutions
LED indicator is not light
1. The charging cable is not fully inserted into the
charging socket.
2. Foreign matter on the metal contact of the charger
oron the battery charging port prevent charging.
3.The charging socket is damaged.
4. Motor of vacuum cleaner damaged
5. Battery damaged.
6.Charger damaged.
1. Make sure the charger, battery, and power socket are in
good contact.
2. Make sure that the charging contact is in good condition
without foreign matter or dust build-up.
3.Change another charging socket.
4. Contact sales@ibuture.com for a replacement motor.
5. Contact sales@ibuture.com for a replacement battery.
6. Contact sales@ibuture.com for a replacement charger.
Electric floor brush roller
does not rotate
1.The roller brush is wrapped or entangled by hair.
2.The roller brush is not installed in place.
3.The extension tube or electric floor brush is not
installed in place.
4. Extension tube damaged.
5. Floor brush damaged.
1. Follow the instructions to clean the floor brush and restart
the vacuum cleaner.
2. Follow the instructions to reinstall the roller brush.
3. Follow the instructions to reinstall the extension tube and
floor brush.
4.Extension tube damaged, please contact the after-sales.
5.The floor brush is damaged, please contact the after-sales.
Vacuum cleaner
leaks dust
1. The HEPA filter is not installed or not in place.
2.The HEPA filter is full of dust.
3.The metal filter is full of dust .
4. HEPA filter damage needs to be replaced.
5. Turn off the vacuum cleaner before the rubbish come
into the dust cup.
1. Check that the HEPA filter is installed in place.
2.Clean the HEPA filter.
3.Clean the metal filter .
4. Contact customer service to purchase a replacement
HEPA filter.
5. Make sure all the rubbish is in the dust cup before turning
off the vacuum cleaner.
The vacuum cleaner stops
automatically
1.0ut of battery.
2. Clogged suction ports cause the vacuum cleaner to
be overheated.
3.Clogged HEPA filter causes the vacuum cleaner to be
overheated.
4. HEPA filter needs to be replaced.
1. Charge the battery.
2.Clean all the air inlets. Let the vacuum cleaner cool to
room temperature before turning it on.
3. Clean up the HEPA filter, dust cup, floor brush and metal
filter.
4. Replace the HEPA filter.
14.@D
X sales@ibuture.com