BW Broadcast TX5 FM Broadcast Transmitter - User Manual

TX5 FM Broadcast Transmitter
No part of this manual may be re-produced in any form without prior written permission from BW Broadcast.
The information and specifications contained in this document is subject to change at any time without notice.
Copyright 2010 BW Broadcast
www.bwbroadcast.com
Technical Manual

Summary

TX5 FM Broadcast Transmitter

Critical Operation and Setup Warnings

Operating Without Load

Warning against operating the transmitter without a suitable antenna or dummy load to prevent damage.

MPX Loopthrough Jumper

Details the function of Jumper J5 for MPX signal input and its setting for external connections.

Introduction to TX5 FM Transmitter

Safety Precautions and Compliance

Quick Setup Guide: Standalone Operation

Quick Setup Guide: With RDS Encoder

Quick Setup Guide: External Audio Processor

Quick Setup Guide: External Processor & RDS (In-line)

Quick Setup Guide: External Processor & RDS (Sidechain)

Front and Rear Panel Layout

Control and Monitor LCD Display

Frequency Setup Procedures

RF Power Output Control

Alarm Monitoring and Conditions

RS232 Control: Windows Application

RS232 Control: Terminal Application

Modes of Operation: Hardware Settings

Modes of Operation: Presets & Pilot Tone

Multiplex;Broadband Input Mode

Stereo with No Processing Mode

Modes of Operation: Stereo;Mono Configurations

Advanced Setup: Multiplex Input

Advanced Stereo Setup Procedure

Advanced Setup: Mono Configurations

Technical Specifications

RF Specifications

Details RF parameters like power, connector type, frequency range, steps, stability, and MPX input characteristics.

Stereo Specifications

Limiter Specifications

Circuit Description: Overview & Combo Board

Circuit Description: Exciter

Circuit Description: LCD Control Board

Circuit Description: Power Amplifier Board

Block Diagram

Internal Wiring and Overview

BW Broadcast TX5 FM Broadcast Transmitter Specifications