GasAlertMicroClip XT
Operator’s Manual
14
To charge the battery, complete the following:
1. Deactivate the detector. Insert the charging
adapter plug into an AC outlet.
2. Connect the charging adapter to the detector
IR interface. Refer to the following illustration.
3. Allow the battery to charge for 2-3 hours.
4. To reach full battery capacity, allow the battery
to fully charge and discharge three times.
5. Charge the battery after each workday.
Maintenance
To maintain the detector in good operating condition, perform
the following basic maintenance as required.
• Calibrate, bump test, and inspect the detector on a
regular schedule.
• Maintain an operations log of all maintenance, bump
tests, calibrations, and alarm events.
• Clean the exterior with a soft damp cloth. Do not use
solvents, soaps, or polishes.
Replacing a Sensor or Sensor Filter
a Warning
To avoid personal injury, use only sensors specifically
designed for the detector.
Use proper ESD handling practices.
a
Caution
Ensure hands are clean or wear gloves before handling
components.
To Next Page
