Need help?Do you have a question about the BW Technologies GasAlert MicroClip XT and is the answer not in the manual?
General| Target Gas | O2, LEL, CO, H2S |
|---|---|
| Detection Range (LEL) | 0-100% LEL |
| Detection Range (H2S) | 0-100 ppm |
| Resolution (O2) | 0.1% Vol. |
| Resolution (LEL) | 1% LEL |
| Resolution (CO) | 1 ppm |
| Resolution (H2S) | 1 ppm |
| Display | LCD |
| Type | Multi Gas Detector |
| Gases Detected | Oxygen (O2), Combustible gases, Carbon Monoxide (CO), Hydrogen Sulfide (H2S) |
| Sensor Type | Electrochemical (O2, CO, H2S), Catalytic (LEL) |
| Detection Range (O2) | 0-30% vol |
| Detection Range (CO) | 0 to 1000 ppm |
| Alarms | Visual, audible, and vibrating alarms |
| Operating Temperature | -20°C to 50°C (-4°F to 122°F) |
| Humidity Range | 0 to 95% RH (non-condensing) |
| Ingress Protection | IP66 / IP67 |
| Certifications | ATEX, IECEx, UL, CSA |
Provides contact information for customer support in various regions and via email/website.
Instructs users to refer to calibration steps for zeroing the detector's sensors.
Advises users to read cautions before operating, including battery disposal and component safety.
Describes error indicators during startup or normal operation for sensors.
Explains the sequence and indicators for a low battery condition.
Details the function and behavior of confidence beeps and IntelliFlash indicators.
Describes the automatic shutdown sequence triggered by critical conditions.
Details the procedure and precautions for replacing sensors or sensor filters.
Step-by-step guide for removing and installing a new sensor filter.
Instructions for replacing the hydrogen sulfide, carbon monoxide, and LEL sensors.
Step-by-step instructions for removing and installing the oxygen sensor.
Details the regulatory approvals and certifications obtained by the detector.
To Next Page
