1
GasAlertMicroClip XT
Introduction
The operator’s manual provides basic information for the
GasAlertMicroClip XT. For complete operating instructions,
refer to the GasAlertMicroClip XT Technical Reference Guide
provided on the CD-ROM. The GasAlertMicroClip XT (“the
detector”) warns of hazardous gas at levels above user-defined
alarm setpoints. The detector is a personal safety device. It is
your responsibility to respond properly to the alarm.
Note
The detector is shipped with English as the default
displayed language. Additional languages provided are
Portuguese, Spanish, German, and French. The screens
for the additional languages are displayed on the detector
and in the corresponding operator’s manuals.
Zeroing the Sensors
To zero the sensors, refer to steps #1-3 in Calibration on page 7.
ec Warning
This instrument contains a lithium polymer battery. Dispose
of lithium cells immediately. Do not disassemble and do not
dispose of in fire. Do not mix with the solid waste stream.
Spent batteries should be disposed of by a qualified
recycler or hazardous materials handler.
Safety Information - Read First
Use the detector only as specified in this manual and the refer-
ence guide, otherwise the protection provided by the detector
may be impaired. Read the following cautions before using the
detector.
a
Cautions
• Warning: Substitution of components may impair
Intrinsic Safety.
• Caution: For safety reasons, this equipment must be
operated and serviced by qualified personnel only.
Read and understand the user manual completely
before operating or servicing.
• Charge the detector before first time use. BW
recommends the detector be charged after every
workday.
• Before using the detector, refer to Sensor Poisons and
Contaminants.
To Next Page
Loading...
Need help?
General
