9
Working from underneath the cover, tighten the
bronze nut by hand, then moderately using a 22
tube wrench. Take care not to damage the o-ring.
10
Mounting the diuser: Centre the diuser in its
housing, and push it rmly against the lid, twist it
to slide the tongue of the diuser fully into the U
shaped groove in the lid.
11 12
• Insert the o-ring into the groove around the periphery of the lid.
• Check that the upper, inner section of the tank and the seal around the lid are clean.
• Remove the plug from the collector pipe and fit the lid onto the tank. The collector pipe should fit
into the diffuser under the lid.
• Put the lid in place following the instructions provided on the following page.
• Using the ring, assemble the lid and tank.
Tighten firmly by hand only.
16/32
2021/01 - Indice de révision : G - Code : 26650 FILTRATION
To Next Page
Loading...