BYD e6A AUTO Owner's Manual
Motor and Chassis 5-9
Check the breather tubes on the transmission
frequently to ensure the normal performance
of these components.
If BYD original transmission fluid is not
available, you can use API certified gear oil
as substitute. For specific specifications,
please refer to Maintenance Manual or
contact BYD authorized service station.
Transmission fluid shall be replaced by
mileage or interval as specified in Periodic
Maintenance Table. The existing transmission
fluid shall be drained completely before filling
new transmission fluid.
Please contact BYD authorized service
station if you have any doubt about checking
fluid level or filling fluid inbox.
Maintenance for rear drive
transmission (if equipped)
After running in a new transmission, drain the
lubricant in the transmission case. Unscrew
the drain plug1 to drain the lubricant and
tighten it again. Then unscrew the filler plug 2
to refill fresh lubricant. ATF220 is
recommended to use. Please keep the filling
amount at about 1.5 L. It is recommended to
replace lubricant at the specified service
station.
Pay attention to check the lubricant amount in
the transmission case during daily operation.
Remove the filler plug, and touch the fluid
level in the plug hole. The normal level should
be up to the edge of the plug hole. Otherwise,
please refill fresh oil approved by BYD until it
over flows from the filler opening. Then screw
the filler plug and tighten it. Replace the
lubricant in the transmission case regularly.
To secure the quality of lubricant, wash and
clean the transmission case before replacing
lubricant.
Check the bolts outside of the transmission
for looseness or absence during daily
operation. If a bolt is found loose, tighten it
timely; if there is any bolt missing, reinstall it.
Keep the bolts and transmission case clean in
order to facilitate heat dissipation.
Check the components of vent ducts on the
transmission frequently to ensure the normal
performance of these components.
To Next Page
Loading...
