BYD e6A - Switch

BYD e6A AUTO Owner's Manual
1-60 Switch
Front headlight
The switch is used to adjust the up/down
beam angle of the front headlights. After the
low beam lights are turned on, the switch can
start to work.
6 gears are provided for the switch. When the
switch is turned upward, the front headlight
beam angle will move upward; when the
switch is turned downward, the angle will
move downward.
vehicle load conditions
Recommended
gear
One person in the driver
seat, and one each in the
driver seat and the front
passenger seat
Gear 0
fully seated
Gear 0.5
fully seated and cargo
loaded
gear 0.5 or
gear 1
driver plus trunk loaded
with the maximum load for
the rear axle
gear 2
1. Mileage change over/reset (ODO/
TRIP) switch
In the ACC gear, every time the switch of
"ODO/TRIP" is pressed, the mileage display
mode in the combination instrument will be
changed once in the following order:
odometer-TRIP A-TRIP B-odometer.
2. Backlight brightness adjustment
switch
In the gear ON, the brightness of the vehicle
backlight can be adjusted by pressing the
button.
a) Daylight mode: before the combination
switch is turned to the position ,
press down the backlight adjustment
button to adjust the backlight brightness of
the combination instrument. Five levels of
brightness (1-5) are provided. Brightness
can be adjusted from level 1 to level 5 in a
circulating way.
Emergency warning light switch
Mileage
changeover
switch
Backlight
brightness
adjustment switch
reversing radar
power switch
Clock adjustment switch
H hour
M minute
R reset
Mode
changeover
switch