BYD e6A - Page 30

BYD e6A AUTO Owner's Manual
1-12 Operation of Instruments and Controllers
(g) Motor Coolant Overheat
Indicator
When this light comes on, it means that the
motor coolant temperature is too high. The
vehicle must be stopped to let the motor cool
down.
The motor may get overheated in the
following operating conditions:
● Driving uphill for a long distance in hot
whether.
● Frequent sudden braking and harsh
acceleration.
● When the vehicle is used to tow another
one.
(h) Power System Malfunction
Indicator
This light will come on when the power
position is switched "ON". It will distinguish in
a few seconds if the power system works
properly. This light will come on again if there
a fault with the system afterwards.
If any of the following conditions occur, it
suggests that there is a fault with the
components monitored by the warning
indicator system. Please contact a BYD
service station for an inspection of the
vehicle:
● This light does not come on or remains on
when the power is switched to "ON" position.
● This light comes on while driving.
The instantaneous flashing of the warning
light during operation is a normal condition.
NOTE
Do not drive the vehicle while the warning
indicator is on - even for a short distance.
Otherwise the motor could be damaged.
(i) Motor Overheat Warning
Indicator
When this light comes on, it means that the
motor temperature is too high. The vehicle
must be stopped to let the motor cool down.
The motor may get overheated in the
following operating conditions:
● Driving uphill for a long distance in hot
whether.
● The vehicle stops and starts frequently in
jammed traffic; frequent harsh
acceleration and sudden braking; or the
vehicle keeps running for a long time
without a break.
● When the car is used to tow another one.
(j) EPS Malfunction Indicator
This light will come on when the power
position is switched "ON". It will go out in a
few seconds if the EPS system works
properly. This light will come on if there a fault
with the system.