BYD e6A - Page 49

BYD e6A AUTO Owner's Manual
Doors and Keys 1-31
If the motor fails to start (the OK light does
not come on)
Restart the engine in the normal starting
procedure.
NOTE
After starting, wait for a few seconds until
the OK light comes on; then slowly release
the brake pedal and the vehicle can be
driven away.
WARNING
● While operating the "ENGINE START
STOP" switch, please stop operating the
switch if it is faulty and contact a BYD
authorized service station immediately.
When Motor Cannot Start
The motor cannot be started in the following
conditions:
 When pressing down "ENGINE START
STOP" switch, if the key position
indicator of the intelligent key
system is on with the buzzer
giving out warning tone and "Key is not
detected" is displayed on the right
information screen, it means the key is
not in place.
 Even if the intelligent key is in the car
(for example, on floor, in cup holder,
trunk or glove box), the motor cannot be
started under such conditions.
When pressing down "ENGINE START
STOP" switch, if the starting function is not
normal, the possible causes are:
 The battery in the intelligent key might
have depleted. The motor can be
started by holding the intelligent key
and approaching it to the "ENGINE
START STOP" switch.
Please replace intelligent key battery.
(Please see "Replace Card-type
Intelligent Key Battery" and "Replace
Electronic Intelligent Key Battery" in this
Section.)
 The motor is started repeatedly in a
short period.
Wait for 10 seconds before starting the
motor again.
If starting fails, an orange indicator on
the "ENGINE START STOP" switch will
flash.