BYD e6A AUTO Owner's Manual
Steering Wheel and Rearview Mirror 1-55
Direction display
An LCD is mounted on the right top of the
inner rearview mirror (as shown in the figure)
to indicate the present direction of vehicle
heading. If the car is used for the first time or
is just overhauled, the direction should be
calibrated.
Inner rearview mirror direction calibration
methods and steps
Please pay attention to the following three
items before direction calibration:
The direction indicatedin the inner rearview
mirror is the direction pointed to by the vehicle
heading, and the display state is called the
normal display state. However, in the state of
calibration, the direction indicated in the inner
rearview mirror just acts as the role of
indication and doesn't represent the direction
of vehicle heading. Then the state is called
the calibration display state;
It is suggested that a clip is used as the
calibration tool;
Before calibration, select an open & smooth
square, a closed-loop block, or an annular
driveway and identify the directions of east,
south, west and north (as shown in the figure).
Calibration steps
Step 1: Start the car. Then a word will appear
in the displaywindowon the top right of inner
rearview mirror. The word may be any one of
east, south, west, north, northwest, southwest,
northeast, and southeast.
Step 2: select the starting position. It may be
east, south, west or north.
Step 3: press the button "Enter" (as shown in
the figure) on the back of inner rearview
mirror with a clip to enter the direction
calibration display state.
To Next Page
Loading...
