BYD e6A - Page 84

BYD e6A AUTO Owner's Manual
1-66 Switch
Configuration 2:
The methods of use for the front wiper
and washer are the same as that for
Configuration 1.
Rear Wiper and Washer
a. By turning the switch knob to the position
"ON", the rear wiper will be started.
b. By turning the switch knob to the position
"OFF", the rear wiper will be stopped.
c. If the switch knob is turned downward
from "ON" to the position , or upward
from "OFF" to the position , the rear
wiper and the rear washer will be started
at the same time.
Outer Power Rearview Mirror
Switch
Adjust the outer rear-view mirrors with this
switch.
1. Selection switch - it is used to select which
rear-view mirror shall be adjusted.
Press the switch to "L" (left) or "R" (right).
2. Control switch - it is used to adjust the
outer rearview mirror.
Press switch as per your demand.
3. Folding switch-it is used for folding outer
rearview mirrors.
When the key is in the position "ACC" or "ON",
the outer rearview mirrors can be adjusted.
NOTE
If the rear-view mirror is frozen, do not
manipulate the controller or scrape the
surface of the rearview mirror. Use a
spraying deicer to remove the ice on the
surface of the rearview mirror.
Power windows
The windows can be operated by switches on
each door.
The key should be in the position "ON".
1
3
2
1
2