BYD AUTO F0 Owner’s Manual
129
2. Use flat screwdriver to unclench
the high mounted brake light.
3. Remove the light holder.
4. Take out the bulb.
The steps of installation is opposite to the
disassembly.
License light
When replacing the bulb of license light,
you should remove the assembly of license
light in the rear bumper, then replace the
bulb.
Friendly Tips
z When plugging in/out the
connectors, if you drop the
connectors into the installation hole
by mistake, please contact the service
store authorized by BYD.
To Next Page
Loading...
