BYD F3DM - Page 199

- 199 -
F3DM Owner’s Manual
booster battery. Disconnect the clamp
of the positive jumper cable from your
vehicle, then from the booster battery.
WARNING
Keep the ends of the jumper cables
away from each other and any metal
on the vehicle until everything is
disconnected.
Do not touch the clamps of the
jumper cables while starting the
vehicle. Otherwise, you may cause
an electrical short.
Any following conditions happened,
please contact your BYD authorized
dealer for a check:
1. The instrument cluster display still
off when power is on.
2. The battery charging system
fault warning light is on in the multi-
information display when power is on.
3. The power battery fault warning light
is on when power is on.
WARNING
y
Make sure the clamps of the
jumper cables connect the right
terminal, and avoid accidentally
touching anything except the
right terminal.
y
Do not touch the clamps of the
jumper cables while starting the
vehicle. Otherwise, you may
cause an electrical short.
y
Do not let the jumper cable
connect the positive (+) terminal
with the negative (–) terminal is
connected.
WARNING
If the auxiliary battery is discharged
with the transaxle in “P”, your
vehicle cannot be moved unless
the front wheels are raised. This
is because the front wheels are
locked by means of the parking lock
mechanism.
Check and Replace Fuses
Fine Blown
A Type
!
!
!
使用手册小330.indd199 2011-4-1318:36:56