BYD F3DM - Parking Brake

- 86 -
F3DM Owner’s Manual
Ignition Switch Equipped with
Steering Wheel Auto-locking
Mechanism
“START” – reserved gear.
“ON” – start DM system and turn on all
the auxiliary equipment.
When the ignition switch is turned
to “ON”, each system of the vehicle
performs self-detection function.
“ACC” – only auxiliary equipment such
as radio can be operated, but other
high-voltage equipment cannot be
operated.
If you open the driver-side door
with the key in the position “ACC”
or “LOCK”, the buzzer will sound to
remind the driver to remove the key.
“LOCK” – DM system stops working
and steering wheel is locked. You can
remove the key only in this position.
Make sure you insert the key
completely before turning it from “ACC”
to “LOCK”.
When you start DM system, if the key
seems to be locked in the position
“LOCK”, firstly you should make sure
the key is inserted completely and then
turn the key while turning the steering
wheel gently
Parking Brake
When parking your car, you must pull
up the parking brake rmly to prevent
the car from sliding.
To set: Pull up the parking brake
handle .For better parking effect, rstly,
depress the brake pedal until the
vehicle completely stops, then pull up
the parking brake handle rmly.
To release: pull up the parking brake
handle (as shown mark 1 in picture
above) gently, then press down the
使用手册小330.indd86 2011-4-1318:36:47