BYD F3DM - Page 201

- 201 -
F3DM Owner’s Manual
WARNING
y
Make sure the key is turned to
LOCK before replacing the fuse.
y
Never use a fuse with higher
amperage rating, or any other
object to replace a fuse. This
may cause serious damage and
possibly a re.
Add Washer Fluid
If the washer does not work, the
washer tank may be empty. Check the
washer level on the content gauge. If
the washer level is below “LOW” mark,
you shall rell the washer.
Before Adding Washer
Pull out Washer funnel and hang it on
the brake of front engine hood support.
You may use plain water as washer
fluid. However, in cold areas where
temperatures range below freezing
point, you have to use washer fluid
containing antifreeze. This product
is available at your BYD authorized
dealer and most auto parts stores.
Follow the manufacturer’s directions
for how much to mix with water.
Make sure to put back the funnel in
place after lling the washer tank.
NOTICE
Don’t use engine antifreeze or any
other substitutes for it will damage
the vehicle paint.
Replace Bulb
The following illustrations show how
to take off the bulbs. When replacing
a bulb, make sure the ignition switch
and light switch are off. Use bulbs with
the wattage ratings given in the table
below.
Parking light and rear parking light
consists of a group of luminous
diodes. When the number of burnt
!
使用手册小330.indd201 2011-4-1318:36:56