BYD HVS 5.1 - 2.1. Intended Use; 2.2. Important Safety Instructions

Shenzhen BYD Electronic Co., LTD 2 Safety
7
HVS&HVM Operating Manual
2. Safety
2.1. Intended Use
The battery system is for residential and works with a photovoltaic system. It is a high voltage
Li-ion battery storage system, with the control module on itself. It could be operated in on-grid,
off-grid and backup modes with compatible inverters.
The battery system could be connected to the Internet through network cable for maintenance
and firmware updating.
The battery system must only be used as stationary equipment.
The battery system is suitable for indoor and outdoor use under the conditions mentioned in
Section 5.1.
The battery system must only be operated in connection with a compatible inverter. The list
(BYD Battery-Box Premium HVS & HVM Compatible Inverter List) of these inverters could be
found at www.bydbatterybox.com.
The battery system is not suitable for supplying life-sustaining medical devices. Please ensure
that no personal injury would lead due to the power outage of the battery system.
Alterations to the battery system, e.g., changes or modifications are not allowed unless the
written permission of BYD is achieved. Unauthorized alterations will void the guarantee and
warranty claims. BYD shall not be held liable for any damage caused by such changes.
The type label should always be attached to the battery system.
2.2. IMPORTANT SAFETY INSTRUCTIONS
The battery system has been designed and tested in accordance with international safety
requirements. However, in order to prevent personal injury and property damage and ensure
long-term operation of the battery system, please do read this section carefully and observe all
safety information at all times.
2.2.1. Battery Module Leakage
If the battery modules leak electrolytes, contact with the leaking liquid or gas should be
avoided. The electrolyte is corrosive, and the contact may cause skin irritation and chemical
burns. If one is exposed to the leaked substance, do these actions:
Inhalation: Evacuate the contaminated area, and seek medical help immediately.
Eye contact: Rinse eyes with flowing water for 15 minutes and seek medical help immediately.
Skin contact: Wash the affected area thoroughly with soap and water and seek medical help
immediately.
Ingestion: Induce vomiting and seek medical help immediately.