Driving in Rain/at
Night
Light Switches
① Light switch: The rst position is to
shut down, the second is for AUTO, the
third is for position light and the fourth
is for low beam. If you choose AUTO, the
position light and headlight will light up
according to the surroungdings.
② Fog light dial: It is used to turn on or
shut down the rear fog light.
Set the light switch to and push the
light switch lever down (away from the
steering wheel) to turn on the high beam.
Wiper Switch
• The lever is used to control the
windshield wipers and washer. It has
ve modes:
•
: High-speed
•
: Low-speed
•
: Auto Wipers/Intermittent
• : Stop
•
: Point-wiping
• To select a mode, push up or pull down
the lever.
• At low- and high-speed modes, the
wiper operates continuously.
•
To let wipers work in the spot-wiping
mode , pull the lever from the
position. The wipers wipe at a low
speed until you release the lever.
•
The automatic wiper function has four
sensitivity levels. The higher the lever,
the higher the sensitivity. When using
the automatic wiper function, change
the sensitivity by adjusting the toggle
based on real-time rain conditions. If
the wiper reacts to rain too quickly,
reduce the sensitivity; if the wiper
reacts to rain too slowly, increase the
sensitivity.
10
To Next Page
Loading...
Need help?
General
