Driving
Power Switch
In normal cases, start the vehicle as
below:
• Carry the correct smart key with you.
• Press the START/STOP① button while
pressing the brake pedal②.
•
The vehicle is ready to drive when
the OK indicator lights up on the
instrument cluster.
Driving
1. Press the brake pedal.
2. Shift into "D".
3. Make sure that "D" gear indicator is
displayed on the instrument cluster.
4. Release the brake pedal.
5. Press the accelerator pedal to start
driving.
Gear Shift Controls
• The gear position of the gear actuator
is marked on the gearshift lever.
• P gear is for parking, press this button
to park the vehicle and the parking
indicator will light up. Press the brake
pedal to start the vehicle, you may
shift from "P" to another position.
•
"R": Reverse, used only when the
vehicle has come to a complete stop.
• "N”: Neutral, used for temporary stop.
•
Under all circumstances, always shift
to "P" before the driver gets out.
• "D": Drive, shift to D position to drive
the vehicle normally.
•
If the shift is successful, the lever
returns to its middle position after it is
released.
• Turn the ignition on before shifting
into "D".
• Shifting out of "P" or into "D" gear
requires pressing the brake pedal and
the UNLOCK button at the same time.
For details, see the prompt message on
the instrument cluster.
Electronic Parking
Brake (EPB)*
• Be sure to engage the EPB every time
before parking and leaving the vehicle.
Engaging EPB manually
• Pull up the EPB switch so that the
EPB applies an appropriate parking
force. The indicator on the instrument
cluster ashes and then is steady
on, indicating that EPB is engaged.
In addition, a text prompt "EPB
activated" is displayed.
7
DRIVING
To Next Page
Loading...
Need help?
General
