02
1-1 Repair instructions
Maintenance instructions :
In order to keep your electric scooter in optimal use, please perform regular maintenance.
Clean and check the following :
※Whether the front/rear tire pressure is within the normal range of 35-40 psi.
※Whether the front/rear tire pattern is lower than the normal value by more than 0.5 mm.
※Whether the frame and components are cleaned.
※Whether the joints and lock points are correct and have signs of corrosion
※Whether the rearview mirror and rear retro reflector are in good condition.
※The motor, battery, controller, and other components do not require maintenance, please do not
disassemble them without authorization. In case of any problems, please immediately send them
for repair.
※The scooter is strictly forbidden from being rinsed with high pressure water in order to prevent
electronic components and wiring from becoming wet and causing accidents.
※
It is strictly forbidden to clean the scooter with corrosive solvents or detergents to prevent discoloration
and deformation of plastic parts and painted surfaces.
※When cleaning the shell, please wipe it with a neutral solution.
※When cleaning the metal part of the scooter shroud, please wipe it with a dry cloth.
※For the internal electrical appliances and wiring of the scooter shroud, please try to avoid contact
with detergents and water. If the surface needs to be wiped, it is recommended to use a dry cloth.
It is recommended that the following parts be oiled and lubricated every 3,000 km or every six months
of use.
1.Front / rear axle
※Oiling is prohibited on the following parts :
shroud, tires, brake drums, electromagnetic brakes, and brake rubber block.
2.Seat holder fixing hole 3.Upper and lower copper
beads set of the center bar
To Next Page
Loading...
Need help?
General
