CAST XFP ANALOGUE ADDRESSABLE FIRE ALARM PANEL
Page 12 of 16 Commissioning/Programming Quick Start Guide Approved Document No. DFU5020010 Rev 4
4.6.2 Assign an Input Device to a Zone
An input device is any device that can signal an event such as ‘fire’, ‘fault’, etc. to the fire alarm panel,
e.g. smoke/heat detectors, MCPs and the input channels of I/O units.
Click on the Loop Summary tab to open the Loop Summary window.
For each input device, click on the drop-down menu in the Zone/Group/Set column to assign a
device to a Zone (see FIG.4).
Note: In order to make any changes to the Zone/Group/Set data in the Loop Summary window,
click on the Enable Type/Zone Changes box.
FIG.4 – Loop Summary Window
To Next Page
Loading...
