CAB EOS2 - Replacing the Control Panel

10 10
2.5 Replacing the Control Panel
4
3
5
1
2
Fig. 5 Removing / mounting the control panel
Removing
 Remove the casing.
 Unlock the control panel (3) at the latch (5) swing it away from the printer and remove it by lifting.
 Unplug the connector of the display cable (4).
Mounting
 Re-connect the cable (4).
 Hook the slot (2) of the cover into the guide (1) and press the control panel against the printer until the latch (5)
clicks into place.
 Mount the casing.
2 Replacing Assembly Units