CABAC UPS600DV3 - Installation Instructions

Customer Care Australia P: 133 122 F: 1300 303 310 E: sales@cabac.com.au W: cabac.com.au
A: 8 Distribuon Pl, Seven Hills NSW 2147
Customer Care New Zealand P: 8 0077 6969 F: 8 0088 6969 E: sales@cabac.co.nz W: cabac.co.nz
10
10 of 21
Installation Instructions
1. Inspection 
InspecttheUPSuponreceipt.The packagingisrecyclable.Saveitforreuseor
disposeofitproperly.EnsuretheUPSisphysicallyundamagedduetotransit.
2. Placement
InstalltheUPSinaprotectedareawithadequateairflow,andawayfromdirect
sunlightandexcessivedust.DonotoperatetheUPSwherethetemperatureand
humidityisoutsidethespecifiedlimitsintheSpecificationsTable.
3. ConnecttoMainsPower
ConnecttheACinputpowercordtoasocketoutlettopoweruptheUPS.
ThebatteryintheUPSwilllosesomechargeduringshippingandstorage.Itwill
recharge completelyafterapproximately8 hoursof normal operation.Do not
expectfullbatteryruntimeduringthisinitialrechargeperiod.
4. Connecttheloads
PlugtheloadsintotheoutputsocketsontherearoftheUPS.EnsuretheUPSis
sizedcorrectlysothattheUPSisnotrunatfullloadconstantly.
Caution: NDO NOT connect a laser printer or plotter to the UPS with other
computerequipment. Alaser printer orplotter periodically drawssignificantly
morepowerthanwhenidle,andmayoverloadtheUPS.