Cactus V6 - Learning a Custom Flash Profile

28
4. Turn the selection dial until the LCD
s h o w s y o u r  a s h m o d e l (e.g. < 58 0E X *>).
Press .
5. Connect the ash unit to the V6. Switch
y o u r  a s h t o T T L m o d e a n d y o u r  a s h w il l
be ready for remote control. The chosen
ash prof ile will be applied until you
choose another ash prof ile.
In case you wish to f ire and control an
on-camera master ash via the V6 TX, follow
steps 2-4 above in TX mode to choose the
appropriate ash prof ile for the master
ash.
If y o u r  a s h m o d e l s a r e n ot i n c l u d e d i n
the pre-installed prof ile list but support
A n a l o g u e T T L, u s e t h e V 6 t o le a r n t h e  a s h
prof iles. Make sure that your ashes are
eligible for the V6 ash prof ile learning
pr o g r a m (s e e S e c t i o n 7.1.3).
1. Switch on one of your V6s in RX mode.
2. Set up your ash on the V6 multi-system
shoe (female). Position the V6 together
w it h y o u r  a s h f a ci n g a w h it e,
matte surface at a distance of
1 meter in a dark environment.
10.2
Learning
a Custom
Flash
Profile